Wheel & Kiln › How big to throw a mug before firing

How big to throw a mug before firing

Throw a mug to hold about 1.47× its finished capacity when wet (12% shrinkage): about 17.6 oz wet for a 12 oz mug and 23.5 oz wet for 16 oz. Low-shrink earthenware (8%) needs about 1.28×, porcelain at 14% about 1.57×.

Wet capacity for a finished mug

Mark 100 mm on a fresh bar.

For the other modes.

Any unit; the answer uses the same unit.

Wet capacity to aim for

Finished (to brim)8% shrink12% shrink14% shrink
8 oz10.3 oz11.7 oz12.6 oz
10 oz12.8 oz14.7 oz15.7 oz
12 oz15.4 oz17.6 oz18.9 oz
14 oz18 oz20.5 oz22 oz
16 oz20.5 oz23.5 oz25.2 oz
20 oz25.7 oz29.3 oz31.4 oz
Advertisement
Ad space

Quick wet capacity check

  1. Put the thrown mug on a scale and tare it.
  2. Pour in water to the brim: every gram is 1 ml (29.6 ml per US fl oz).
  3. Compare with the chart and adjust the next ball by roughly 1 oz of clay per oz of capacity.

Do this on the first mug of a set while it is still on the bat, then tip the water out and let the mug firm up as usual. For clay weights see clay for a mug.

Questions potters ask

How big should I throw a 12 oz mug?

With 12% shrinkage, throw it to hold about 17.6 oz to the brim while wet. Measure with water before you trim, or fill a jug to the target and pour it in.

Why are my mugs too small after firing?

Usually the wet capacity was planned with linear, not volume, shrinkage. A 12% shrink takes about a third off capacity. Trimming and a heavy handle push the brim level lower too.

Is mug capacity measured to the brim?

On this site, yes. A mug filled to a comfortable drinking level holds about 80–85% of its brim capacity, so a 12 oz brim mug serves about 10 oz.

How we estimate clay: the finished pot's wall and base volume × the fired density of the body, converted back to wet clay using typical water content and loss on ignition, plus a trimming and throwing allowance. Cone temperatures: Orton Ceramic Foundation published equivalents for self-supporting cones (°C converted). Glaze and plaster maths use standard slurry density relationships. Always follow your clay and glaze supplier's own data and safety sheets.