Wheel & Kiln › Clay shrinkage calculator

Clay shrinkage calculator

Shrinkage % = (wet length − fired length) ÷ wet length × 100. Most mid-fire stoneware shrinks 11–13%, so a pot you want 4 inches wide must be thrown about 4.55 inches wide. Capacity shrinks by the cube: at 12% linear shrinkage a pot loses about 32% of its volume, so to finish at 12 oz it must hold about 17.6 oz wet.

Clay shrinkage calculator

Mark 100 mm on a fresh bar.

For the other modes.

Any unit; the answer uses the same unit.

Wet size multipliers

Total shrinkageThrow size × (length)Wet capacity × (volume)Volume lost
6%× 1.064× 1.217%
8%× 1.087× 1.2822%
10%× 1.111× 1.3727%
11%× 1.124× 1.4230%
12%× 1.136× 1.4732%
13%× 1.149× 1.5234%
14%× 1.163× 1.5736%
15%× 1.176× 1.6339%
Advertisement
Ad space

Making a shrinkage ruler

Once you know your clay's shrinkage, mark a strip of card with the wet lengths of finished inches or centimetres (for 12%, each finished inch is 1.136 inches wet). Measure wet pots with it and read finished sizes directly.

Drying vs firing shrinkage

Add the optional bone-dry measurement to the test bar calculator to split the total. Drying shrinkage that is very high compared with firing shrinkage often means a very plastic, wet clay that is more prone to warping and cracking while drying.

Questions potters ask

How do I measure clay shrinkage?

Roll a slab, cut a test bar and scratch two marks exactly 100 mm apart while it is wet. Measure again after bone dry and after the glaze firing. If the marks end 88 mm apart, the clay shrinks 12% in total.

How much does stoneware shrink?

Most mid-fire stoneware shrinks about 11–13% from wet to cone 6. Earthenware is often 5–9% at low fire; porcelain can be 13–15% or more. Your supplier's data sheet gives the figure for your clay.

How much does a pot's volume shrink?

Much more than its height: 12% linear shrinkage takes about 32% off capacity, because width, depth and height all shrink. A 16 oz mug must hold about 23.5 oz when wet.

Does clay shrink more when fired hotter?

Yes, up to its maturing temperature. Over-firing can also cause bloating or slumping, so fire to the cone the clay is designed for.

Why measure from wet, not dry?

Because you throw and measure wet. A fired-from-dry figure misses the drying shrinkage, which is often half the total.

How we estimate clay: the finished pot's wall and base volume × the fired density of the body, converted back to wet clay using typical water content and loss on ignition, plus a trimming and throwing allowance. Cone temperatures: Orton Ceramic Foundation published equivalents for self-supporting cones (°C converted). Glaze and plaster maths use standard slurry density relationships. Always follow your clay and glaze supplier's own data and safety sheets.