Wheel & Kiln › Glaze batch calculator
Glaze batch calculator
Grams of each material = its percentage ÷ the base total × batch size. For a 5,000 g batch of a recipe totalling 100, 25% feldspar is 1,250 g. Additions (colourants, opacifiers) are a percentage of the base added on top, so 4% iron oxide adds 200 g and the bucket gets 5,200 g of dry material.
Example: 5,000 g batch
| Material | Recipe % | Grams |
|---|---|---|
| Potash feldspar | 25 | 1,250 |
| Silica | 25 | 1,250 |
| Whiting | 20 | 1,000 |
| Kaolin | 20 | 1,000 |
| Talc | 10 | 500 |
| Red iron oxide (addition) | +4 | 200 |
An illustrative recipe for the maths only, not a tested glaze. Use recipes from your supplier, teacher or tested sources.
Weighing tips
- Weigh each material onto a separate sheet or bowl, tick it off, then add to the water. It is easy to lose track of a 25% ingredient.
- A scale reading to 0.1 g matters for small additions: 0.5% of a 100 g test batch is only 0.5 g.
- Sieve the glaze (80 mesh is common) after mixing, and check specific gravity before you glaze.
Questions potters ask
How do I scale a glaze recipe?
Divide each base material's percentage by the total of the base (usually 100), then multiply by the batch size. Additions such as colourants and opacifiers are calculated as a percentage of the base on top, so a 5,000 g batch with 4% iron adds 200 g.
Why doesn't my recipe add up to 100?
Many published recipes total 98 or 103 after rounding, or list additions separately. The calculator normalises the base to 100 and keeps additions on top, which is the usual convention.
How much water do I add to a glaze?
Start with roughly 90–100 ml of water per 100 g of dry glaze for dipping, then adjust to the specific gravity you want. Enter a target SG in the calculator to estimate it.
What batch size should I mix?
Test tiles: 100 g. A small dipping bucket: 2–3 kg dry. A full 5 gallon bucket at dipping consistency: about 10–12 kg (22–27 lb) dry.
Is mixing glaze safe?
Dry glaze materials are hazardous to breathe. Wear a properly fitted respirator rated for fine particles when weighing and mixing, work wet where possible, clean up with a damp sponge, and read each material's safety data sheet.
How we estimate clay: the finished pot's wall and base volume × the fired density of the body, converted back to wet clay using typical water content and loss on ignition, plus a trimming and throwing allowance. Cone temperatures: Orton Ceramic Foundation published equivalents for self-supporting cones (°C converted). Glaze and plaster maths use standard slurry density relationships. Always follow your clay and glaze supplier's own data and safety sheets.