Wheel & Kiln › How much plaster for a mold?

How much plaster for a mold?

Measure the inside of the mold box, subtract the model, then mix about 0.93 kg of plaster and 0.65 kg of water per litre at a consistency of 70. An 8 × 6 × 4 inch pour needs about 7.1 lb of plaster and 2.4 quarts of water, including 10% extra.

How much plaster for a mold?

Inside the cottle or box.

Optional.

Pottery plaster is often 70.

Plaster for common pours (consistency 70, +10%)

Box (L × W × depth)PlasterWater
6 × 4 × 3 in2.7 lb / 1.2 kg0.9 qt / 0.8 L
8 × 6 × 4 in7.1 lb / 3.2 kg2.4 qt / 2.3 L
10 × 8 × 5 in14.9 lb / 6.7 kg5 qt / 4.7 L
12 × 10 × 6 in26.7 lb / 12.1 kg9 qt / 8.5 L
Advertisement
Ad space

Volume of the model

Subtract the model's volume if it is large compared with the box. For a cylinder use π × r² × h, or sink the model in a full container of water and measure what overflows (seal porous models first). Leave at least 1 to 1.5 inches of plaster around the model for strength and absorbency.

Wear a dust mask when handling dry plaster, and never pour plaster down a drain.

Questions potters ask

How much plaster and water do I mix?

At a consistency of 70 (70 parts water to 100 parts plaster by weight), each litre of mold needs about 934 g of plaster and 654 g of water.

What is plaster consistency?

The parts of water per 100 parts plaster by weight. Lower numbers give harder, denser, less absorbent molds; pottery plaster for slip-casting molds is commonly mixed at about 65–75. Use the manufacturer's recommended figure.

Should I add plaster to water or water to plaster?

Sift plaster into the water, let it soak (slake) for 2–3 minutes, then mix. This avoids lumps and air.

How much extra should I mix?

About 10% covers what sticks to the bucket and fills the spare. It is easier to discard a little than to mix a second batch mid-pour.

How we estimate clay: the finished pot's wall and base volume × the fired density of the body, converted back to wet clay using typical water content and loss on ignition, plus a trimming and throwing allowance. Cone temperatures: Orton Ceramic Foundation published equivalents for self-supporting cones (°C converted). Glaze and plaster maths use standard slurry density relationships. Always follow your clay and glaze supplier's own data and safety sheets.