Wheel & Kiln › Glaze specific gravity calculator
Glaze specific gravity calculator
Specific gravity = grams ÷ millilitres of a well-stirred sample: 145 g in 100 ml is SG 1.45, a common dipping consistency. To thin a glaze, add water; the calculator gives the amount. For example, 10 litres at 1.55 needs about 2.2 litres of water to reach 1.45.
Water per 100 g of dry glaze
| Target SG | Water | Dry glaze per litre of slurry |
|---|---|---|
| 1.3 | 167 ml | 488 g |
| 1.35 | 137 ml | 569 g |
| 1.4 | 115 ml | 650 g |
| 1.45 | 98 ml | 731 g |
| 1.5 | 85 ml | 812 g |
| 1.55 | 73 ml | 894 g |
| 1.6 | 64 ml | 975 g |
Assumes a typical dry material density of 2.6 g/cm³.
Typical ranges
| Application | Specific gravity |
|---|---|
| Spraying | 1.30–1.40 |
| Dipping | 1.40–1.50 |
| Pouring liners | 1.45–1.55 |
| Brushing | 1.50–1.70 (often with a brushing medium) |
Questions potters ask
What specific gravity should glaze be?
Common ranges: about 1.40–1.50 for dipping, 1.30–1.40 for spraying, and 1.50–1.70 for brushing glazes. Follow the recipe's notes; matte and crawl-prone glazes are often used thinner.
How do I measure specific gravity?
Weigh a measured volume. Tare a cup on a scale, fill to the 100 ml line with well-stirred glaze and read the grams: 145 g means SG 1.45. A hydrometer reads it directly.
My glaze is too thick. How much water do I add?
For 10 litres at SG 1.55, about 2.2 litres of water brings it to 1.45. Add a little less than calculated, stir thoroughly, and re-measure.
My glaze is too thin. What do I do?
Let it settle overnight and siphon or ladle clear water off the top, then stir and re-measure. The calculator shows how much water to remove (a negative amount).
Why does the same SG behave differently?
Flocculation (thixotropy) changes how glaze hangs on the pot. Two glazes at 1.45 can give different thicknesses, so record both SG and dip time for your glazes.
How we estimate clay: the finished pot's wall and base volume × the fired density of the body, converted back to wet clay using typical water content and loss on ignition, plus a trimming and throwing allowance. Cone temperatures: Orton Ceramic Foundation published equivalents for self-supporting cones (°C converted). Glaze and plaster maths use standard slurry density relationships. Always follow your clay and glaze supplier's own data and safety sheets.